My DSP Club

?找回密码
?如何免费获得现金红包

QQ登录

只需一步,快速开始

搜索
热搜: Bonus NPS SWAT e-DSP
查看: 5040|如何免费获得现金红包: 2
打印 上一主题 下一主题

Epsa code

[复制链接]

1

主题

2

帖子

19

积分

新手上路

Rank: 1

积分
19
跳转到指定楼层
楼主
发表于 2015-3-17 11:21:41 | 只看该作者 回帖奖励 |倒序浏览 |阅读模式
本帖最后由 fairy_chen 于 2015-3-17 13:33 编辑

Battery
Error code number Error Message Action to be Taken Conclusion/Cause
2000-0131 Battery – The battery is not installed Install the battery.
Check for debris or damaged contacts.
Battery
2000-0132Battery – The battery is reaching the end of its usable life Consider replacing battery. Battery
AC Adapte
Charging Circuit Board
System Board
2000-0133Battery – The battery cannot provide sufficient power Check contacts, power plug and cables.
may need to replace battery.
Battery
AC Adapte
Charging Circuit Board
System Board

Charger
Error code number Error Message Action to be Taken Conclusion/Cause
? ? 2000-0134 Charger – Charge cycles exceeded maximum limit Check for User Error.
Re-seat the battery and re-run the test.
Check for latest BIOS.
Battery
Charger
? ? 2000-0135 Charger – Unable to detect charger Check for User Error.
Re-seat the battery and re-run the test.
Check that charger is connected to the computer or replacing it.
Check for latest BIOS
Battery
Charger
? ? 2000-0136Charger – Unexpectedly detected chargerUser Error.
The charger has not been removed as directed – remove the charger.
Check for latest BIOS.
NA
? ? 2000-0137 Charger – The charger is not supplying power User Error.
Re-seat battery.
Check for latest BIOS.
Battery
Charger

Fans
Error code number Error Message Action to be Taken Conclusion/Cause
? ? 2000-0511 Fan – The (S) fan failed to respond correctlyCheck for latest BIOS.
Re-run the test.
If the problem persists, it may be a faulty fan.
Fan(S)
System Board
? ? 2000-0512 Fan – The (S) fan is running faster than expected Check for latest BIOS.
Re-run the test.
If the problem persists, it may be a faulty fan.
Fan(S)
System Board

Merroy
Error code number Error Message Action to be Taken Conclusion/Cause
2000-0123 Memory – integrity test discrepancy. (S)Power down system, re-seat memory DIMMS.
Retry??, if no error occurs then it was a DIMM connection issue.
Check for latest BIOS.
Memory DIMMS
System Board
Processor

Storage Devices
Error code number Error Message Action to be Taken Conclusion/Cause
2000-0141 Hard Drive – No Hard Drive detectedThis device is not required on notebooks so this message may be understood as a warning message.
If a HDD should be present:Power down system; reconnect hard drive to the System Board. Rerun the diagnostic. If no error occurs then it’s a cable or connector issue.
Reflash latest BIOS.
If errors persist, update device firmware.
Hard Drive
System Board
2000-0142 Hard Drive (D) – S/N (S), self-test unsuccessful. Status = (X) Power down system; reconnect hard drive from system board. Rerun the diagnostic. If no error occurs then it’s a cable or connector issue.
Reflash latest BIOS.
If errors persist, update device firmware.
Hard Drive
System Board
2000-0145 Hard Drive (D) – S/N (S), self-test did not completePower down system.
Reconnect hard drive from System Board. Rerun the diagnostic.
If no error occurs then it’s a cable or connector issue.
Reflash latest BIOS.
If errors persist, update device firmware.
Hard Drive
System Board
2000-0147 Optical Drive (D) – Self test: (S)User Error.
Reconnect optical drive into system board.
Rerun the diagnostic. If no error occurs then it’s a cable or connector issue.
Re-flash latest BIOS.
If errors persist, update device firmware.
Optical Drive
System Board
2000-0150 Hard Drive – No Hard Drive detected User Error.
Warning message but cabling or connectivity may be an issue.
Reflash latest BIOS.
If errors persist, update device firmware.
Hard Drive
System Board
2000-0151 Hard Drive (D) – S/N (S) incorrect status = (X) – (S)User Error.
Re-run the test.
Check cables and connections.
Reflash latest BIOS.
If errors persist, update device firmware.
Hard Drive
System Board
2000-0152Optical Drive (D) – Incorrect status = (X) (S) User Error.
Re-run the test.
Re-flash latest BIOS.
Re-seat optical drive to system board.
If errors persist, update device firmware.
Optical Drive
System Board
2000-0156Tape (D) – SN(S)
Tape Drive D - S/N S, no media, cannot test drive
User Error.
Tape Media is not installed. Install media.
Tape Drive

OS Boot Path does not test hardware, but checks the suitability of the operating system’s Master Boot Record and related structures for booting into the operating system control. If these structures have been damaged or tampered with, this test provides an indication of the best course of action.
Error Number Error Message Action to be TakenConclusion/Cause
? ?2000-0166 OS - Suspect corrupt MBR, verify MBR with Anti-Virus Application Run anti-virus software on the system. Reinstall or update OS

System Board (All non-UEFI systems. NOTE: UEFI does not support hardware IRQ’s)
Error Number Error Message Action to be Taken Conclusion/Cause
2000-0111CPU (D): (S) exception occurredFlash latest BIOS and retry.System Board
2000-0112CPU (D) - machine check exception detectedFlash latest BIOS and retry. System Board
2000-0212System board - CMOS, Location = (X), Expected = (X), Found = (X)Flash the latest BIOS and retry the diagnostics.System Board
2000-0213System board - CMOS battery failure detectedFlash the latest BIOS and retry the diagnostics.
Reseat CMOS batter
CMOS battery
System Board
2000-0221System board - Interval timer not functionalFlash the latest BIOS and retry the diagnostics.System Board
2000-0233System board - RTC 'seconds' count is not updatingFlash the latest BIOS and retry the diagnostics.System Board
2000-0234System board - HPET (D), incorrect time period. Expected = (D), Found = (D)Flash the latest BIOS and retry the diagnostics.System Board
2000-0241BIOS – A20 gate not enabledFlash the latest BIOS and retry the diagnostics.System Board
2000-0242System board - Interrupt controller, IRQ = (D): (S) not detectedFlash the latest BIOS and retry the diagnostics.System Board

Event Log
Error NumberError Message?? Action to be TakenConclusion/Cause
2000-0251 Event Log - The log contains failing records Event Log provides various BIOS and Diagnostic events. Event Log provides various BIOS and Diagnostic events.

Thermals
Error Number Error Message??Action to be TakenConclusion/Cause
2000-0314Thermal: The (S) reading (DC) exceeds the thermal limit.Check Event Log for events related to the system’s thermal solution: defective fans, clogged air paths, defective sensors.
Check for latest BIOS.
Fans
Air paths
Sensors
BIOS
2000-0315Sensor: The (S) reading (DC) is lower than expected.Check the Event Log for entries involving sensors reading zero degrees.
Check for latest BIOS.
Sensors??
BIOS

Touchpad
Error??Number Error Message Action to be TakenConclusion/Cause
? ?2000-0313Touchpad - Pointing stick/touchpad not detectedFlash latest BIOS, reconnect touchpad and retry??the diagnostics.Connections cables??
Touchpad
System??Board

1

主题

2

帖子

19

积分

新手上路

Rank: 1

积分
19
沙发
?楼主| 发表于 2015-3-17 13:33:40 | 只看该作者
Notebook Panel
Error??NumberError MessageAction to be??TakenConclusion/Cause
2000-0321LCD??EDID – Unable to access EDID EEPROMFlash??latest BIOS and retry diagnosticLCD??cable
LCD pane
System Board
??2000-0322LCD??panel – Unable to modify brightnessFlash??latest BIOS and retry diagnosticLCD??cable
LCD panel inverter/controller
System Board
??2000-0324LCD??panel - User reported LCD BIST colors were not displayedPossibly??User Error. If not flash latest BIOS and retry diagnosticLCD??cable
LCD panel inverter/controller
System Board
??2000-0325LCD??panel - User provided no input for LCD BISTPossibly??User Error. If not flash latest BIOS and retry diagnosticLCD cable
LCD panel inverter/controller
System??Board
??2000-0326LCD??panel - Unable to turn lamp on or offFlash??latest BIOS and retry diagnosticLCD cable
LCD panel inverter/controller
System??Board
??2000-0327LCD??panel - Unable to use BIOS interfaceFlash??latest BIOS and retry diagnosticLCD cable
LCD panel inverter/controller
System??Board
??2000-0328LCD??panel - Unable to detect??variance in ambient light sensorFlash??latest BIOS and retry diagnosticLCD cable
LCD panel??inverter/controller
BIOS
System Board
Video Card
Error??NumberError MessageAction to be TakenConclusion/Cause
??2000-0331Video??controller - No video controller detectedFlash??latest BIOS and retry diagnosticCables
Video Card
System??Board
??2000-0332Video memory - Video??memory integrity test discrepancyFlash latest BIOS and retry diagnosticCables
Video??Card
System Board
??2000-0333Video - User provided??no input for graphics testPossibly User error.??If not flash latest BIOS and retry diagnosticLCD BIST available &??Graphics visible
? ? Video Controller
? ? System Board
LCD BIST??available & Graphics not visible
? ? LCD cable or panel
? ? Video Controller
? ? System Board
LCD BIST??not available & Graphics visible
? ? Keyboard or keyboard cable
? ?System Board
Graphics??not visible
? ? LCD or LCD cable
? ? System Board
2000-0334Video - User reported the patterns were not displayedPossibly User error. If not flash latest BIOS??and retry diagnosticLCD BIST available &??Graphics visible??
? ?Video Controller
? ?System Board
LCD BIST Graphics not visible
? ?LCD cable or panel
? ?Video Controller
? ?BIOS
? ?System Board
LCD BIST??is not available Graphics visible
? ? Keyboard or keyboard cable
? ? System Board
Graphics??are not visible
? ? LCD or LCD cable
? ? System Board

Cables
Error??NumberError MessageAction to be TakenConclusion/Cause
2000-0415Cables – Check the following cables (S)Re-flash latest BIOS Check the cable(s) specified in the error message. Retry the diagnostics. If no error occurs then it’s a cable or connector issue.BIOS
Secure cables at headers. Replace any damaged cables or devices.
The cables test will pass if all required cables are properly installed but fails if any required cable is not in the expected state
The user should view the configuration information and determine if any optional items that were purchased are showing as Not Installed, and should be Installed. Then check the hardware to be sure the device is properly attached in the system.
System Board
2000-0416Cables - BIOS reports no testable cablesThe system may not have any testable cables.
Check??latest BIOS
N/A

本版积分规则

?
?
咨询建议
工作时间:
9:00-17:00
?

站点统计|小黑屋|GCK GDF ??

GMT+8, 2019-9-19 01:53 , Processed in 0.219574 second(s), 27 queries .

Powered by Discuz! X3.1

? 2001-2013 Comsenz Inc.

快速如何免费获得现金红包 返回顶部 返回列表